Nevergreen Pools installs and services pool automation & control in Paradise Valley, covering automation system installation and retrofits on Pentair IntelliCenter and EasyTouch, Hayward OmniLogic and OmniHub, and Jandy iAquaLink, along with low-voltage and communication wiring, pump, heater, and valve scheduling, pH and ORP sensing, and app setup and homeowner training.

Call us if the app shows the equipment online but nothing at the pad responds, if the schedule stopped running the pumps, heater, or lights at the times you set, if the touchscreen at the pad is frozen or will not accept input, if you are still switching pool and spa by hand because the valve actuators never got wired into the system, if the pH or ORP reading on the panel does not match a test kit anymore, if the chemical feeder is dosing constantly or not at all, or if a remodel or new equipment left part of the system running on the old mechanical timer instead of the automation.

We serve Paradise Valley in partnership with Beyond Pool Cleaning, a pool service company based nearby. Call to get a technician scheduled, or book your first visit online.

How We Retrofit and Program Automation

An automation system that is not working right costs money every month it goes on, not just once. A pump running on one fixed speed around the clock instead of a programmed schedule burns power on the pool's biggest electrical draw day and night. A gas heater without a set schedule gets left on standby or run at the same temperature for the spa and the pool, adding real dollars to the bill month after month. And a homeowner who has to walk out to the equipment pad to switch valves between the pool and spa, or start the pump by hand because the schedule is not holding, spends time every week doing something the system was built to do on its own.

The first visit starts with a walk of the equipment pad to see what is actually installed. Many of these homes have a decade or more of retrofits stacked on top of each other, and negative edges, water features, and in-floor cleaning systems each need their own sensor, valve actuator, or dedicated pump wired into the controller. On custom builds the plumbing rarely matches a standard layout, so we trace it and confirm what feeds what before touching anything. We check the existing controller, whether it is a Pentair IntelliCenter or EasyTouch, a Hayward OmniLogic or OmniHub, or a Jandy iAquaLink, and test the low-voltage and communication wiring runs first, since a loose or corroded connection at the pad is the most common reason a schedule stops holding or the app loses contact with the equipment.

From there we program the system to match how the pool is actually used, not a generic default schedule. That means:

• Pump speeds set separately for filtration, cleaning, spa jets, and any water features, so the pump is not running full speed for a job that needs a fraction of the flow
• Heater set points and run windows programmed so the spa heats fast without leaving the pool heater on standby all day
• Valve actuators programmed for clean pool and spa switching, including any negative edge or water feature that shares plumbing with the main pool
• pH and ORP sensors calibrated and checked against a manual test, with dosing limits set so a feeder cannot overdose or run dry without an alert
• App access set up and tested from the homeowner's own phone, not just the panel at the pad

Once the system is programmed, we commission it on site, running through pool mode, spa mode, and any water feature or cleaning cycle while watching the pad to confirm every pump, valve, and relay is doing what the schedule says it should. We walk the homeowner through the app before we leave, so changing a schedule or checking on the pool later does not require a call to us for anything routine.