Nevergreen Pools provides pool service in Chandler, covering weekly maintenance and water chemistry, green pool and algae clean-ups, filter cleaning and repair, pump, heater, and salt cell repair or replacement, automation, and new equipment installation.

Call us if you see a white scale line building on the tile that a hose will not rinse off, if the water level drops faster than evaporation can explain, if the pump is louder than it used to be or will not hold prime, if the salt cell stops producing chlorine and the water will not hold a reading, if the pool turns green within a day or two after a monsoon dust storm, if the heater fires but the spa never gets warm, if the automation panel stops responding to its schedule, or if filter pressure climbs fast between cleanings.

We serve Chandler in partnership with Beyond Pool Cleaning, a pool service company based nearby. Call to get a technician scheduled, or book your first visit online.

How Weekly Service Works Here

The first visit is a walkthrough of the equipment pad and a full read of the pool. We test the fill water, check the plaster or pebble finish for etching or staining, and look at the condition of the filter, pump, heater, and salt cell along with the plumbing and valves at the pad. That gives us a baseline for a Chandler pool before we start a weekly schedule, so we know what is original equipment and what has already been replaced. On homes from the 1990s and 2000s that still have original equipment, that walkthrough is often the first time anyone has actually looked closely at the shaft seal, the cell plates, or the automation wiring since installation.

Every weekly visit after that follows the same routine: test the water and dose by the actual reading rather than a fixed amount, skim the surface, empty the skimmer and pump baskets, brush the walls and steps, vacuum as needed, and check the equipment pad for anything that has started leaking, tripping, or making noise. Filter cleanings and cell inspections are scheduled off pressure readings and output, not a calendar, so they get done when the equipment actually needs it.

• Check basket, lid, and pad plumbing for anything that has started weeping or backing off
• Test and balance chlorine, pH, alkalinity, and stabilizer to the reading
• Skim the surface and empty skimmer and pump baskets
• Brush walls, steps, and tile line, and vacuum when debris has settled
• Inspect the salt cell and clean it when scale buildup shows up
• Backwash or clean the filter when pressure rises above the baseline
• Walk the deck and water line for anything the last monsoon storm left behind

Repairs and Equipment

When something is wearing out, we flag it on the visit report before it fails, not after. Every repair gets quoted in writing and, if you approve it, it is done by the same tech who services your pool rather than handed off to a subcontractor. That matters on a Chandler HOA property where owners are gone most of the day and the timeline for getting someone on site has to actually work around that. We also check backup power and surge protection on automation panels, since a power blip during a monsoon storm is a common reason a schedule gets wiped and never gets reset.

Repair or replace comes down to the age of the part and what it costs to keep running against what a new one costs to buy. A newer pump with a bad capacitor or a heater with a failed igniter is worth repairing. A single-speed pump or an original heater from the early 2000s usually is not, because the monthly cost of running old equipment adds up faster than the cost of replacing it. Variable-speed pumps get programmed to the pool's actual turnover and feature schedule rather than left on a default program, and salt cells and heaters get sized to the pool and spa volume instead of matched to whatever was there before. Automation gets tied into the schedule so filtration, cleaning, and spa heat run without you touching a panel.