Nevergreen Pools provides pool service in Granite Bay, covering weekly maintenance and water chemistry, green pool and algae clean-ups, filter cleaning and repair, pump, heater, and salt cell repair or replacement, automation, and new equipment installation.

Call us if the plaster or pebble finish feels rough or chalky instead of smooth, if the tile line is losing its finish and starting to etch, if the water level is dropping faster than evaporation can explain, if the pump is grinding or humming without starting, if the salt cell has stopped producing chlorine, if the pool turns green within days of the first hot week, if acorns and oak leaves are filling the skimmer baskets faster than you can keep up, or if the spa, water feature, or in-floor cleaning system has stopped cycling on schedule.

Nevergreen Pools is a licensed pool company based in Shingle Springs, serving the Sacramento region. Call to get a technician scheduled, or book your first visit online.

How Weekly Service Works Here

The first visit starts with a walk of the equipment pad and a full water test on your fill water, since the water here in Granite Bay comes off the lake soft and low in calcium and alkalinity, which changes how we balance everything after. We check the plaster or pebble finish for etching or rough spots, inspect the filter media, look over the pump and motor, test the heater, check the salt cell for wear, and check the visible plumbing at the pad for corrosion at unions and valves, since many of these pads sit on long runs set well away from the house. We also note the age and condition of the equipment on the pad and the condition of the deck, so nothing shows up as a surprise on a later invoice. That gives us a condition report before we set a chemistry program, not after.

After that, the weekly visit follows the same pattern every time. We test and dose based on that day's reading rather than a fixed schedule, since soft water needs careful attention to keep it from pulling calcium out of plaster and metal. We skim, empty baskets, brush the walls and steps, vacuum as needed, and check the equipment pad, clearing oak debris out of the baskets before it packs down. Filter cleaning and salt cell cleaning are scheduled off pressure and output readings, not the calendar, because a filter that is still moving water well does not need to be pulled apart yet.

• Test and balance chlorine, pH, alkalinity, calcium, and stabilizer, adjusted for soft fill water and bather load
• Skim the surface and empty skimmer and pump baskets
• Brush walls, steps, and the waterline where finish wear shows first
• Vacuum the pool and clear oak leaves and acorns as they collect
• Check pump, filter pressure, heater operation, and salt cell output
• Backwash or clean the filter and inspect the cell when readings call for it
• Check the deck and equipment pad for anything that needs attention before it becomes a repair

Repairs and Equipment

When something on the pad needs attention, we flag it on the same visit, write up what we found and what it costs to fix, and send our own techs to do the repair rather than handing it to a subcontractor. That keeps one team responsible for the pool from the weekly test strip to the motor swap.

Old equipment gets a straight answer on repair versus replacement. Many pools in Granite Bay were built in the 1980s through the early 2000s and are still running original heaters and single-speed pumps that were never upgraded. A heater with one bad part or a pump that still runs quiet is usually worth repairing. A heat exchanger that has pitted from years of soft water, or a pump running on bearings that are already howling, usually is not, because the running cost and failure risk of an old unit outweighs a repair bill within a season or two. Any pump we install gets programmed as a variable-speed unit with separate speeds for filtration, cleaning, spa, and any water features, since running a pool on one fixed speed wastes electricity every day it operates. New equipment gets sized to the pool's actual volume and plumbing, not swapped one for one for whatever failed, because the long plumbing runs common out here put real strain on an undersized or oversized pump. We also check that the existing plumbing and electrical can support the new equipment before we install anything, since retrofitting a variable-speed pump onto old wiring is its own job.