Professional Pool Service
Nevergreen Pools runs ongoing pool maintenance plans in Granite Bay, CA, covering chemistry, filters, and equipment checks for aging pools and spas.
Nevergreen Pools provides pool maintenance in Granite Bay, covering full-service plans, chemical-only service, filter and cell cleaning, seasonal chemistry adjustments, and equipment checks that track a pool's condition over time.
Call us if the plaster or pebble finish feels rough or pitted even when the water tests clean, if acorns and oak leaves fill the skimmer baskets faster than you can keep up, if the in-floor cleaning heads have stopped popping up in order, if the spa won't hold a set temperature anymore, if the automation panel controls don't match what actually turns on, if a raised wall or water feature has started staining where the water runs down it, or if the pump is original to the pool and only runs at one speed.
Nevergreen Pools is a licensed pool company based in Shingle Springs, serving the Sacramento region. Call to get a maintenance plan started, or book your first visit online.
Most of what we maintain here is a larger custom pool built in the 1980s through the early 2000s, often with an attached spa, a raised wall or water feature, and an in-floor cleaning system, running on an original pump, heater, and automation panel that were never upgraded. The first visit starts with a walk of the equipment pad and a full water test, since the lake-sourced water here runs soft, with low calcium and alkalinity that pulls minerals out of plaster and pebble finishes and out of heater exchangers if the balance isn't held. We check the finish for etching, inspect the filter media, look over the pump, heater, and salt cell, test the spa's heater and jets on their own cycle, and run the in-floor cleaning system through a full rotation to confirm every head is popping up and shutting off in order. We log the age and condition of everything on the pad, since equipment this old is closer to the end of its service life than a homeowner usually expects. That gives us a condition report before we set a plan, not after.
From there you choose full service or chemical-only. Full service covers everything below. Chemical-only covers water testing and dosing on every visit, with the homeowner or another crew handling skimming, brushing, and vacuuming. Either way, the visit follows the same pattern.
Seasonal adjustments follow summer heat near and above 100 degrees, which burns off chlorine fast and pushes algae growth, and winter, when bather load drops and heater run time on the spa goes up instead. We log filter cleans, cell cleans, and equipment age on every visit, so when a pump or heater is getting close to the end of its service life, you hear about it months ahead of a failure instead of the day it quits.
When something on the pad needs attention, we write up what we found and what it takes to fix it on the same visit, and our own techs handle the repair instead of handing it off. A single-speed pump that is still running quiet and a heater with one bad part are usually worth repairing. A pump running on bearings that already hum or grind, or a heat exchanger that has scaled past the point of a quick fix, usually is not, since the running cost of an old single-speed pump outweighs a repair bill within a season. Any pump we install gets programmed as variable speed, with separate settings for filtration, the in-floor cleaner, and the spa, since running this kind of pool on one fixed speed wastes power every day the equipment runs. A lot of pads here sit well away from the house at the end of a long plumbing run, so we check pipe size and valve condition before swapping in new equipment, since undersized pipe will choke a variable-speed pump no matter how well it's programmed.
A pool on a real plan holds clear water, a spa that heats on command, a filter that doesn't choke mid-season, and a salt cell that keeps producing chlorine instead of scaling over. The in-floor system keeps circulating water into corners a single return never reaches, and a raised wall or water feature keeps running without the staining that soft, poorly balanced water leaves behind. Skip the plan and the costs show up slower but bigger: a heater exchanger scaled past saving, a pump that seizes instead of just wearing out, plaster etched deep enough to need resurfacing years early. None of that is cheap to walk back once it has happened.
Call Nevergreen Pools to get a plan set up, or schedule your first visit online. We will walk the pad, test the water, and tell you straight whether your equipment needs attention now or can run another season.
Related services in Granite Bay: Weekly Pool Service in Granite Bay and Pool Pump Repair in Granite Bay.
