Nevergreen Pools provides weekly pool service in Glendale, covering water testing, chemical dosing by reading, skimming, brushing, vacuuming, basket cleaning, and equipment checks on the same day every week.

Call us if the tile line is building a ring of scale that will not wipe off, if a mechanical timer is stuck running on the wrong schedule, if the water level keeps dropping faster than evaporation accounts for, if the filter pressure climbs higher every week between cleanings, if the salt cell has stopped producing chlorine, if the pool turns cloudy or green after a monsoon dust storm, or if seed pods and leaves are filling the skimmer baskets faster than a biweekly visit can keep up with.

We provide this service in partnership with Beyond Pool Cleaning, a pool service company based nearby. Call to get a technician scheduled, or book your first visit online.

The Weekly Visit, Step by Step

The first visit depends on what's on the pad and in the shell. An older plaster pool from the 1960s through 1980s usually runs on a mechanical timer, with aging plumbing and a pump or heater that has been patched more than once. A newer pool with a pebble finish, a salt system, and a variable-speed pump needs a different starting checklist, mostly around programming and cell output rather than plumbing condition. Either way, the first visit starts with a full water test, a check of the plaster or pebble finish for etching or scale, and a walk of the equipment pad to note the age and condition of the pump, filter, heater, and any visible wear at the unions and valves. That gives us a condition report before we set a chemistry program, not after. On the older systems, we also check the timer's contacts and gears, since a worn timer is one of the most common reasons a pump stops turning on schedule without tripping a breaker.

After that, the visit runs on the same day every week, since chlorine demand shifts fast once temperatures climb into the 105 to 115 range and evaporation pulls water down daily. We test and dose based on that day's reading rather than a fixed amount, skim the surface, empty the skimmer and pump baskets, brush the walls, steps, and waterline where scale forms first, and vacuum as needed. Filter pressure gets tracked every visit and logged, so a cleaning happens when the reading calls for it rather than on a guess. On pools with a salt system, we check cell output the same way. Weekly service catches all of this before it becomes a problem; a biweekly schedule leaves too many days for chlorine to burn off and algae to get a start, especially once monsoon dust storms start loading pools with dirt overnight.

• Test and balance chlorine, pH, alkalinity, and stabilizer, adjusted for the day's heat and bather load
• Skim the surface and empty skimmer and pump baskets
• Brush walls, steps, and the waterline where scale forms first
• Vacuum as debris and monsoon dust require
• Check pump, filter pressure, heater operation, and salt cell output where equipment allows
• Clean or backwash the filter when pressure readings call for it
• Check the timer settings and equipment pad for anything that needs attention before it becomes a repair

On older systems still running on a mechanical timer, we check that the timer is set correctly for the season, since a timer left on a winter schedule through summer means the pump isn't running long enough to keep up with heat and bather load. Mature trees on older lots drop leaves and seed pods year round, not just in one season, so basket checks matter every single visit no matter the month. Hard water scales tile lines and heaters over time regardless of pool age, so we watch for buildup early rather than after it has already etched into the tile.