Nevergreen Pools provides weekly pool service in Tempe, covering water testing and chemical dosing, skimming, brushing, vacuuming, basket cleaning, and equipment checks on the same day every week.

Call us if you're the one skimming the surface every few days because nobody is testing the water between visits, if you're brushing the tile line yourself because a ring of scale keeps coming back, if you're running out to empty the baskets before they overflow and choke the pump, if the water level keeps dropping faster than evaporation explains, if the filter pressure gauge keeps climbing and nobody has tracked what it read last week, if the pump hums or grinds without starting, or if a monsoon storm leaves the pool cloudy and full of dust the next morning.

We serve Tempe in partnership with Beyond Pool Cleaning, a pool service company based nearby. Call to get a technician on a weekly schedule, or book your first visit online.

How Weekly Service Works Here

The first visit starts with a full water test and a walk of the equipment pad, since a lot of pools in this area are on original or once-replastered plaster from the 1960s through the 1980s, running older skimmers and main drains, single-speed pumps, and sand or DE filters that are close to the end of their working life. We check the skimmer and main drain fittings, look at the filter media, test the pump and motor, check the heater, and note the filter pressure so there is a number to compare against later. On rental and investment properties, we also check how long it has been since anyone serviced the pool, since gaps between tenants are common and a pool can sit for weeks without attention. That gives us a starting point before we set a chemistry program, not after.

After that, the visit lands on the same day every week, not a rotating schedule, so the pool never goes more than seven days without a full check. We test chlorine, pH, alkalinity, and stabilizer that day and dose based on the actual reading, since chlorine burns off within hours once temperatures hit 105 to 115 degrees, and a fixed dose is either too much or not enough depending on bather load and how recently it stormed. We skim the surface, empty the skimmer and pump baskets, brush the walls, steps, and waterline where scale forms first in this hard water, and vacuum as needed, which runs heavier from July through September when monsoon dust storms load the pool with fine dirt overnight. Palm, citrus, and mesquite debris gets cleared the same way, visit to visit, instead of piling up between a biweekly tech's stops. We also track filter pressure and salt cell output visit to visit instead of cleaning on a fixed calendar, since a filter still moving water well does not need to be pulled apart yet.

• Test and balance chlorine, pH, alkalinity, and stabilizer based on that day's reading
• Skim the surface and empty skimmer and pump baskets
• Brush walls, steps, and the waterline where scale builds first
• Vacuum as debris and monsoon dust require
• Check pump operation, filter pressure, and heater function
• Track filter pressure and salt cell output over time to catch wear before it becomes a breakdown
• Flag anything on the equipment pad, like an aging single-speed pump or a filter near the end of its life, before it fails outright

Weekly beats biweekly here for a simple reason. At 105 to 115 degrees, evaporation is extreme and chlorine demand changes fast, so a pool checked every other week can swing from properly balanced to green or scaling in the days between visits. A rising filter pressure reading or a pump starting to strain gets caught on a weekly visit before it turns into a repair bill, where a biweekly schedule can miss that same problem for two weeks running.