Nevergreen Pools provides pool maintenance in Rocklin, with plans ranging from full-service weekly visits to chemical-only accounts for owners who handle their own cleaning. Each plan covers water testing and chemical balance, filter and cell cleaning on a schedule tied to actual readings, and seasonal adjustments as bather load and temperature change through the year.

Call us if the pool looks cloudy even a day or two after it was serviced, if a white crust is building on the tile line that will not brush off, if the plaster near the steps or benches feels rough or pitted, if the cartridge filter is clogging every week or two instead of lasting a full month, if chlorine reads fine in the morning and is gone by afternoon, if leaves and acorns are filling the skimmer baskets faster than once a week, or if the water has a dull, slightly gray cast instead of being clear.

Nevergreen Pools is a licensed pool company based in Shingle Springs, serving the Sacramento region. Call to set up a plan, or book your first visit online.

How a Maintenance Plan Is Set Up

The first visit is a condition check, not just a chemical dose. We test the fill water along with the pool water, since the local supply comes from the Placer County system and runs soft, with low calcium hardness and low alkalinity. That combination lets pH drift on its own and, left alone, etches plaster over time instead of scaling it, which is the opposite problem homeowners usually expect. We check the plaster or pebble finish for pitting or rough spots, inspect the filter media or cartridge, look at the pump and motor, and check the salt cell for output if the pool is on a salt system. We also note the age of the equipment on the pad, since a plan is built around what that equipment can still do, not just around a chemical schedule.

From there the plan runs on what the pool needs, not a fixed script. A full-service plan includes testing and dosing, skimming, brushing, basket cleaning, and vacuuming on every visit. A chemical-only plan covers the water chemistry piece and leaves cleaning to the homeowner. Either way, filter cleans and salt cell cleans are scheduled off pressure and output readings rather than the calendar, because a cartridge that is still flowing well does not need to come apart yet, and one that is fouled by spring pollen needs attention early regardless of the date.

• Test and balance chlorine, pH, alkalinity, and calcium hardness, adjusted for soft fill water
• Raise calcium hardness where needed to protect plaster from etching
• Skim the surface and empty skimmer and pump baskets, more often during leaf and catkin drop
• Brush walls, steps, and benches where plaster wear shows first
• Check filter pressure and clean or backwash based on the reading, not a set interval
• Check pump operation, heater function if installed, and salt cell output on salt systems
• Log equipment age and condition on the pad so replacement decisions come with data behind them

Adjusting for the Season

Summer highs over 100 degrees push chlorine demand up and evaporate water fast enough that owners often mistake evaporation for a leak, so visits in June through September run heavier chlorine doses and closer attention to water level. Through fall, oak leaves, catkins, and acorns load up skimmer baskets between visits, and in spring, pollen is fine enough to pack into a cartridge filter and choke flow within days. The plan shifts basket checks and filter cleans around these periods instead of holding to the same routine year round, since pools here mostly see daily use from May through October and sit quieter the rest of the year.