Professional Pool Service
Pool pump repair in Rocklin, CA from Nevergreen Pools. We fix leaking seals, noisy bearings, failed capacitors, lost prime, and cracked housings.
Nevergreen Pools provides pool pump repair in Rocklin, covering shaft seal leaks, noisy or failing bearings, motors that won't start, lost prime, cracked pump housings, clogged impellers, and air leaks at the lid o-ring. Most pump problems show up in late spring, when a pump that ran at low speed all winter gets put back to full run time and a weak capacitor, worn bearing, or dried-out seal finally gives out under the load.
Call us if the pump hums or clicks but the motor will not turn over, if there is water pooling under the pump housing, if the pump loses its prime and needs re-priming every time it is turned on, if you hear a grinding or screeching noise from the motor end, if the housing has a visible crack or a weep at the seam, if oak leaves and acorns are clogging the impeller and cutting flow, or if the lid will not hold a seal and the pump keeps sucking air.
Nevergreen Pools is a licensed pool company based in Shingle Springs, serving the Sacramento region. Call to get a technician scheduled, or book your first visit online.
We start at the pump, not the breaker panel. If the motor hums without turning, we check the capacitor first, since a bad start capacitor is the most common reason a pump will not start even though it is getting power. If the motor turns but sounds like it is grinding or screeching, we pull the motor and check the bearings by hand, feeling for play or roughness in the shaft. A bearing that is already loud enough to hear from the deck is close to seizing and gets replaced before it takes the motor with it.
Leaks get traced to one of three places: the shaft seal, the housing itself, or the lid o-ring. A shaft seal leak shows up as water weeping from the base of the motor housing while the pump runs, and the fix is a seal replacement, not a full pump swap. A cracked housing, usually from age or a stress crack that opened up once the plastic flexed under heat, has to be replaced outright since a cracked housing cannot be sealed reliably. A dry or flattened lid o-ring lets the pump pull air instead of water, which shows up as bubbles at the return and a pump that will not hold prime. We replace the o-ring and check that the lid threads and basket seat properly before closing it back up.
Once we know what failed, we give a straight answer on motor swap versus full pump replacement. If the housing, seal plate, and wet end are in good shape and only the motor failed, swapping the motor is usually the right call and costs less than a new pump. If the pump is an old single-speed unit, or the motor has already failed more than once, replacing the whole pump with a variable-speed unit is usually the better move, since a variable-speed pump pulls a fraction of the power at the lower speeds used for normal filtration and recoups the cost over a few seasons. We size any replacement pump to the plumbing and pool volume already in place rather than swapping one for one, since an oversized pump wastes electricity and wears out early.
A pump that starts every time, holds prime, and runs quiet means the filter is actually turning over the water on schedule, which keeps chlorine doing its job during the stretch from May through October when the pool sees the most use. It also means the equipment pad is not sitting in standing water or running the pump dry and burning out a seal from lack of lubrication. A pump in good repair keeps the rest of the pad working the way it should, since a struggling pump makes the filter and heater work harder than they need to.
Left alone, a small problem gets expensive fast. A shaft seal leak that is ignored will eventually let enough water past to damage the motor windings, turning a seal replacement into a full motor replacement. A pump that keeps losing prime and running dry, even for short stretches, burns out the seal and bearings well before their normal life. A cracked housing that is not replaced will eventually fail outright, usually during the hottest week of summer when the pool needs it most. Call us at the first sign of noise, a leak, or a pump that will not hold prime, and we will get a technician out before it turns into a bigger repair.
Related services in Rocklin: Pool Repair in Rocklin and Weekly Pool Service in Rocklin.
